Comfortable pressure at the tap is around 3 bar. Below 1.5 to 2 bar, the shower becomes weak and some water heaters or mixer taps work poorly. The most reliable solution is a booster pump fed from a reservoir (ground tank or cistern), not a pump connected directly to the meter. But you first need to check that the problem really does come from the mains pressure.
Finding the real cause
| Observation | Probable cause |
|---|---|
| Weak everywhere, especially at peak times | insufficient mains pressure at the end of the line |
| Weak only upstairs or on the terrace | height to climb: about 1 bar lost every 10 m |
| Weak on hot water only | scaled-up water heater, blocked safety group, pipe too narrow |
| Weak at a single tap | scaled-up aerator or cartridge |
| Gradual drop over several years | scaled-up or undersized galvanised pipes |
A pressure gauge screwed onto an outdoor tap, at different times of day, gives the answer in a few minutes.
How a booster pump is set up
- A water reserve: ground tank or cistern, fed from the mains through a float valve. It protects the public network and provides autonomy in case of a supply cut (see water tank and cistern).
- The booster pump, with a bladder tank (pressure vessel) and a pressure switch, or a variable-speed pump that maintains constant pressure and starts less abruptly.
- Dry-run protection, a non-return valve and isolation valves for maintenance.
- A ventilated room or shelter, in the shade, with a floor drain in case of a leak, and anti-vibration mounts to limit noise.
Connecting a pump directly to the utility's supply (Radeema, Lydec, ONEE depending on the city) must be avoided: it draws water from the network, disrupts the neighbours and can cause backflow. Check your utility's conditions.
Too much pressure: the pressure reducer
The opposite problem also exists: at the bottom of a neighbourhood or after a poorly adjusted booster, the pressure can exceed 4 to 5 bar. Flexible hoses and mixer taps wear out, water hammer appears, and some water heater manufacturers warn of a risk of damage above 5.5 bar. A pressure reducer set at around 3 bar, fitted after the meter, solves the problem.
Indicative prices
In Morocco, a domestic booster pump can be found from a few hundred dirhams for a small entry-level model, and around 3,000 to 3,500 DH for a good-quality stainless steel unit according to listings surveyed in 2026; the tank, accessories and installation must be added. These amounts are indicative.
The role of the engineering firm
The engineering firm calculates the required flow rate and pumping head (number of outlets, floors, pressure losses), selects the pump and the reserve volume, and plans the plant room. An oversized pump consumes energy and wears out for nothing; an undersized one does not solve the problem.
Frequently asked questions
What is the right water pressure in a house?
About 3 bar at the tap; below 1.5 to 2 bar comfort drops, and above 4 bar it is advisable to install a pressure reducer.
Can a booster pump be connected directly to the meter?
It should be avoided: the pump draws from the public network and disturbs the neighbours. The proper setup is to pump from a ground tank or cistern filled by the mains.
How much does a booster pump cost in Morocco?
According to listings surveyed in 2026, from a few hundred dirhams for a small model to about 3,500 DH for a stainless steel unit, excluding tank and installation; these prices are indicative.
A project in the pipeline?
SIGMA ICC designs reinforced concrete, electrical, plumbing and HVAC systems and supervises sites for villas, riads, hotels and shops.
Sources : Thermor, réducteur de pression et chauffe-eau · Espace Aubade, rôle du réducteur de pression · Selectra, réglage du réducteur de pression.