A lifting station (or pumping station) becomes essential as soon as part of your wastewater is lower than the sewer it must reach: a basement with a bathroom, hammam or laundry, a villa built below street level, a subdivision whose low point is below the public network. A tank collects the water by gravity, then a pump lifts it under pressure up to a manhole at the right level.
How it works
- A watertight tank (sump) that receives the water and acts as a buffer.
- One or two submersible pumps controlled by floats or level sensors.
- A rising main fitted with a non-return valve and an isolation valve.
- A high-level alarm, which gives warning before an overflow.
- Ventilation of the tank, to remove gases and prevent odours.
The right design choices
| Item | Benchmark |
|---|---|
| Pump type | Sewage pump (or macerator pump) as soon as there are toilets; a clear-water pump is not suitable |
| Discharge diameter | At least 80 mm with toilets; 32 mm possible for wastewater without toilet waste (according to standard NF EN 12056-4 and the manufacturer) |
| Number of pumps | Two alternating pumps for a building, a hotel or a collective network, to provide backup |
| Tank volume | From a few dozen litres for a single appliance to several cubic metres for a subdivision; it is calculated from the flows and the permitted number of starts |
| Protection against backflow | Rising main brought up above street level before joining the sewer |
In Marrakech, also think about power cuts and storms: an alarm relayed to an occupied room and, for a building open to the public, a backup power supply prevent a basement from being flooded with wastewater.
Private or public station?
In a villa, the station is private: you buy it, install it and maintain it. In a subdivision whose low point cannot reach the public network by gravity, the VRD engineering firm provides a collective lifting station, designed according to the requirements of the network operator, which may take it over after acceptance. Before going down that route, it always checks whether a different alignment or levelling allows gravity flow to be kept: a station has operating costs and can break down.
Maintenance
- Clean and rinse the tank, the pump and the floats regularly, following the manufacturer's instructions.
- Test the alarm and the changeover between pumps.
- Do not flush wipes, grease or textiles: they are the main causes of blockages.
The role of the engineering firm
The engineering firm compares the levels of the project and the public network, decides whether lifting is needed, calculates flows, total head and useful volume, and integrates the station into the sewerage drawings and into the building's electrical load assessment.
Frequently asked questions
When is a lifting station needed?
As soon as drains are lower than the public sewer or the receiving tank, for example in a basement with sanitary facilities or a villa below street level.
What diameter for the discharge pipe?
As a general rule at least 80 mm when the station receives toilets; a 32 mm diameter can only be considered for wastewater without toilet waste, according to the manufacturer.
Does a lifting station need an alarm?
Yes, a high-level alarm is strongly recommended to give warning before an overflow, especially in the event of a pump failure or a power cut.
A project in the pipeline?
SIGMA ICC designs reinforced concrete, electrical, plumbing and HVAC systems and supervises sites for villas, riads, hotels and shops.
Sources : FFB, raccordement à une station de relevage · Futura, pompe de relevage.